Technical Data - Electrolux TK GL5 E User Manual

16 electrolux
Problem
Drying cycle ends shortly after
programme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically (see „Drying cycle
complete ").
1) only for dryers with DRYNESS function available
Changing the bulb for interior lighting
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local service centre.
Important! When the appliance is switched
on, the interior lighting switches itself off after
4 minutes when the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Before replacing the bulb, disconnect
the mains plug; with a permanent con-
nection: fully unscrew or deactivate the
fuse.

Technical data

Height x width x depth
Drum volume
Depth with loading door open
Height can be adjusted by
Weight when empty
Loading volume (depends on programme)
Voltage
Required fuse
Total power
Energy efficiency class
Energy consumption (8 kg of cotton, pre-drained
2)
at 1000 rpm)
Possible cause
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room tempera-
ture.
1. Unscrew cover above the bulb (this can
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gas-
ket before screwing back the door light cov-
er. Do not operate the dryer when missing o-
ring gasket on door light cover.
85 x 60 x 58 cm
108 l
109 cm
1.5 cm
approx. 40 kg
1)
max. 8 kg
220-230 V
10 A
2350 W
B
4.48 kWh
Select time programme or high-
er drying level (e.g. EXTRA DRY
(Extratrocken) or STRONG DRY
instead of CUPBOARD DRY
(Schranktrocken); ).
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately
spun.
Automatic process, there is no
fault with the appliance. If possi-
ble, lower the room tempera-
ture.
be found directly behind the loading aper-
ture, at the top; refer to "Description of
machine" section.)
Warning! For safety reasons, the cover
must be screwed down tightly. If this is
not done, the dryer must not be
operated.
Remedy