Electrolux TK GL5 E User Manual page 19

2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
Electrical connection
Details on mains voltage, type of current and
the fuses required should be taken from the
type plate. The type plate is fitted near the
loading aperture (see "Product description"
chapter).
Connect the machine to an earthed
socket, in accordance with current wir-
ing regulations.
Warning! The manufacturer declines
any responsibility for damage or
injury through failure to comply with
the above safety precautions.
Should the appliance power supply
cable need to be replaced, this must
be carried out by our Service Center.
Warning! The plug must be
accessible after installing the
machine.
Door reversal
Warning! Before changing the door
stop, disconnect the mains plug.
1.
A
A
Open loading door.
2. Unscrew hinge A from the front of the
machine and take off the loading door.
3. Remove cover plates B . To do this, in-
sert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block C from the
snap-on fixture, take out and re-insert on
the other side having rotated the block
through 180°.
5. Unscrew hinge A from the loading door,
rotate through 180°, re-insert on the op-
posite side and screw down.
6. Re-insert cover plates B on the opposite
site having first rotated them through
180°.
electrolux 19
B
C
B