Component Checklist
Check you have received all parts against this component checklist prior to installation
Upright Pole
Donut
Clamp (x4)
Attach Upright Pole to Base
A
Attach the Upright Pole to the Base
as shown below. Ensure the Cable
Slot faces towards the rear.
Back
Upright Pole
Cable Slot
TIGHTEN
FIRMLY
freestanding quad
Important Notes
l Each Donut Clamp Assembly supports a maximum weight of 11.5kg (25lbs)
l This product suits VESA compliant displays with 75mm x 75mm (3" x 3") and
100mm x 100mm (4" x 4") mounting hole patterns.
l The manufacturer does not accept responsibility for incorrect installation
TOOLS REQUIRED:
Horizontal
Phillips Head Screw Driver
l
Support Donut(x1)
B
Follow steps below to attach the Horizontal Support and Donut Clamp
assembly onto the Upright Pole. Ensure the Cable Slots in all the Poles are
facing to the rear.
B.2.
Slide the Horizontal Support
to desired position
POSITION
IMPORTANT:
When tightening the Donut Clamp,
each of the Donut bolts must be
tightened evenly, as failure to do so
will damage the Donut Clamp. Do
not over-tighten as this may also result
User
in damage.
M8x50mm Screw
5mm Allen Key
visidec
Base
Install Horizontal Support and Donut Clamp
Installation Instructions
Bits Box
M8x50mm
Cable
Screw
Ball (x8)
(x1)
2.5mm Allen
Key (x1)
5mm Allen
Key (x1)
B.1.
Loosen the Hex screws in the
Horizontal Support Donut using
the supplied 5mm Allen Key
LOOSEN
Cable
Slot
TIGHTEN
Repeat steps B.1, B.2 and B.3
for the 2nd set of Horizontal
Support and Donut Clamp
Cable
Extension
Clip (x4)
Clip (x16)
Mounting Screws
M4x10mm (x16)
M4x12mm (x16)
M4x16mm (x16)
LOOSEN
B.3.
Tighten supports firmly
using the supplied 5mm
Allen Key
TIGHTEN
Need help?
Do you have a question about the Freestanding Quad and is the answer not in the manual?
Questions and answers