Advertisement
Quick Links
Step 6. Cable Management - Ensure Arm is fully extended.
Route the Cables underneath the Arms,
inserting the Primary and Secondary
Arm Cable Covers to hold the Cables in place.
TIP: Leave enough slack in the cables
at the joints to allow full movement.
Insert cables into
slot, using Cable
Balls to hold them
in place.
Insert Primary
Arm Cable Cover*
Cable
Balls (x2)
*To insert Cable Covers:
A. Insert tabs...
Installation Complete
Your Visidec Focus Notebook Mount installation is complete and ready for use.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 22.04.09 ©
Insert Secondary
Arm Cable Cover*
TIP: If the Visidec Focus
Arm is to be used in a
multi-user environment,
Cable
use the supplied Cable
Clip
Clip to secure the cables
to the Pole.
B. Push in...
C. Then push up
VF-AT-NP
IMPORTANT:
The "User Operating
Card" must be left with
Visidec Focus Articulated
Arm once installed.
Component Checklist
Notebook Tray and
Arm Assembly
Pole Assembly
TOOLS REQUIRED:
3
/
IMPORTANT INFORMATION
! IMPORTANT - Install Visidec Focus Notebook Mount as per Installation Instructions.
! This product is designed to be used in conjunction with an external keyboard and mouse.
! Visidec Focus Notebook Mount supports Notebooks up to 18", weighing up to 8kg (17
! The Manufacturer accepts no responsibility for incorrect installation.
Step 1. Check Components
Check you have received all parts against the Component Checklist and Hardware above.
Step 2. Desk Mounting (Bolt Through or Desk Clamp)
Option A - Bolt Through
Drill a 9mm (
3
/
") hole in the Work
8
Surface at the desired position and
assemble as shown.
Work Surface
(rear edge)
NOTE: It is recommended that
the Pole Assembly be mounted
towards the rear edge of the
Work Surface.
Installation Instructions
visidec
Focus Notebook Mount
Desk Clamp
Pressure
M8 Desk
5mm Allen
Plate
Clamp Screw
Hardware
Primary Arm
Pole Top
Cap
Cable Cover
Bolt Through
Secondary Arm
Base
Cable Cover
Steel Washer
Cable Balls (x2)
") Drill Bit
8
1
/
Pole Assembly
Bolt Through
Base
9mm (
/
") Hole
3
8
Steel Washer
M8 Desk Clamp Screw
(found in the Desk
5mm Allen Key
Tighten Firmly
Desk Clamp
Key
Bracket
Self Adhesive
Hook-and-Loop
Fasteners (x4 sets)
M8x30mm
Screw
Cable Clip
lbs).
2
Clamp Box)
Advertisement
Related Manuals for Atdec Visidec VF-AT-NP
Summary of Contents for Atdec Visidec VF-AT-NP
- Page 1 VF-AT-NP Installation Instructions IMPORTANT: Step 6. Cable Management - Ensure Arm is fully extended. The “User Operating visidec Route the Cables underneath the Arms, Card” must be left with inserting the Primary and Secondary Visidec Focus Articulated Focus Notebook Mount Arm Cable Covers to hold the Cables in place.
- Page 2 Step 2. Desk Mounting (Bolt Through or Desk Clamp) Step 4. Install the Notebook Computer Install the M8 Desk Clamp Screw Adjust the height of the Pressure Option B - Desk Clamp A. Adjust the Support Tabs and Pressure Plate as shown. Plate to suit the Work Surface and to suit the width of your Tighten Firmly in desired location.
Need help?
Do you have a question about the Visidec VF-AT-NP and is the answer not in the manual?
Questions and answers