Atdec Freestanding Quad Installation Instructions page 2

Adjust Donut Clamps
C
Follow steps below to adjust the position of Donut Clamps. Ensure the Cable Slots
in all the Poles are facing to the rear.
C.1.
Loosen Donut Bolts evenly
using the supplied 5mm
Allen Key
LOOSEN
Mount Displays
D
Choose the correct Mounting Screws supplied in the bits
box and attach the display as shown.
Note: Extension
Clips are included
to suit VESA 100mm
x 100mm (4" x 4")
Mounting Hole
Patterns.
Adjust Ball Joint Mechanism
E
Adjust the Ball Joint
Mechanism to suit the
weight of your display.
Tighten or loosen
screws evenly with the
supplied 2.5mm Allen
Key, 1/4 turn at a time.
As LCD Manufacturers are constantly releasing new monitor models, Atdec does not accept responsibility it the mounting hole pattern does not comply with the international VESA standards.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 29.08.07©
C.2.
Slide the Donut Clamp to
desired position
POSITION
100mm (4")
75mm (3")
75mm
(3")
2.5mm
Allen Key
LOOSEN
TIGHTEN
C.3.
Tighten Donut Bolts firmly
using the supplied 5mm
Allen Key
TIGHTEN
Cable Management
F
Insert display cables into the slots in each pole, using
Cable Balls to hold them in place.
Note: When the slot in each pole cannot be used, use
the supplied Cable Clip's to secure the display cables.
Cable
Balls
100mm
(4")
IMPORTANT:
When tightening the Donut
Clamp, each of the Donut
bolts must be tightened
evenly, as failure to do so will
damage the Donut Clamp.
Do not over tighten as this
may also result in damage.
Cable
Clips
Note: Ensure enough
slack is left in cables to
allow for movement.