Electrolux TW SL6 E User Manual page 47

1)
Problem
The appliance is in the stand-by mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus function was in minimum
mode.
Unsatisfactory
The heat exchanger filters is clogged.
drying results.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the inner surface of the drum.
Too high water hardness.
The filter not locked in the position.
The door
does not
The laundry is locked between the door
close.
and the seal.
You try to change the programme or the
function after the start of the cycle.
Err (Error) on
The function you try to activate is not
the display.
applicable with the selected pro-
gramme.
No drum light
Defective drum light.
Abnormally
The time to end is calculated on the ba-
elapsing time
sis of the volume and dampness of the
on the dis-
laundry.
play.
Programme
The water container is full.
inactive.
Too small laundry volume.
Drying cycle
too short.
The laundry is too dry.
The filters are clogged.
Too high volume of the load.
Drying cycle
The laundry not spun sufficiently.
5)
too long
Very high room temperature - this is not
the appliance malfunction.
1) If there is an error message on the display (e.g. E51 ): Turn the tumble dryer off and on. Make a selection of the
new programme. Activate the Start/Pause function. Does not operate? - contact the service centre and give the
error code.
2) follow the programme description — see PROGRAMMES chapter
3) see CARE AND CLEANING chapter
4) see section WATER HARDNESS in HINTS AND TIPS chapter
5) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Possible cause Remedy
Push the On/Off button.
Do the selection of the applicable pro-
2)
gramme.
3)
Clean the filter.
Change the Dry Plus function to the
moderate or maximum mode.
Clean the heat exchanger filters.
Obey the maximum load volume.
Clean the airflow grill in the bottom of
the appliance.
Clean the inner surface of the drum.
Set applicable water hardness
Put the filter in the correct position.
Put the load correctly in the drum.
Turn the tumble dryer off and on. Make
the new selection.
Turn the tumble dryer off and on. Make
the new selection.
Contact the service centre to replace
the drum light.
The automatic procedure — this is not
the appliance malfunction.
Drain the water container
Start/Pause function.
Do the selection of time programme.
Do the selection of time programme or
higher drying level (e.g. Extra Dry )
Clean the filters.
Obey the maximum load volume.
Spin correctly the laundry.
If possible, lower the room temperature.
electrolux 47
3)
4)
.
3)
, activate the