Removing The Cover; Attaching The Cover; Auto Ignitor Battery Change; Special Information - Truma S 3004 P Operating Instructions Manual

Removing the cover

Do not remove the cover unless the heater is switched
off and has cooled down.
The cover is unlocked by pushing the two locking levers (1)
outwards simultaneously. It can be swivelled out and lifted
from the lower bearings.
1
Fig. 7

Attaching the cover

Hook cover into the lower bearings (1) and swivel in (2) until
catch audibly engages. Pull cover to make sure that it is se-
curely attached.
1
Fig. 8
6

Auto ignitor battery change

If no ignition spark is heard during start-up or only at intervals
of more than one second, the battery must be replaced.
Always ensure that the heater is switched off before replac-
ing battery. Insert a new battery at beginning of every heating
season! Dispose of old batteries properly!
Always use temperature resistant (+70 °C), leakproof Mignon
batteries (LR 6, AA, AM 3) (part no. 30030-99200), other bat-
teries could cause malfunctions!
Remove cover, slide battery compartment cover upwards and
change the battery. Pay attention to positive / negative. Close
battery compartment again. Re-attach the cover.
Fig. 9

Special information

If the vehicle floor is being coated with underfloor protection,
all heater parts located beneath the vehicle must be covered
so that the resulting spray mist does not cause heater sys-
tem malfunctions. Remove covers again when the work is
complete.

Disposal

Dispose of the device and battery in the auto ignitor sepa-
rately in accordance with the administrative regulations of the
relevant country of use. National regulations and laws (in Ger-
many, for example, the End-of-life Vehicle Regulation) must
be observed.
In other countries, the relevant regulations must be observed.
2