Trigger Adjustment - Graco Contractor PC Operation, Parts, Repair

Setup

Trigger Adjustment

The trigger can be adjusted to different
lengths depending upon user preference.
1. Relieve pressure. See Pressure Relief
Procedure, page 5.
2. Loosen adjustment knob (13c). Use a
flat blade screwdriver or coin if the knob
(13c) cannot be loosened by hand.
Complete one full turn to loosen the
adjustment knob. Three full turns could
result in the adjustment knob falling out.
3. Hold end of trigger (13b) and slide to
desired position.
NOTE: Hold trigger in location shown when
adjusting.
4. Tighten adjustment knob (13c) firmly.
6
NOTE: If trigger is too difficult to slide, use a
flat blade screwdriver to slide it down and
apply grease to the location shown.
3A6285D