Install Tip And Tip Guard On Gun; Connect Gun To Sprayer - Graco Contractor PC Operation, Parts, Repair

Install Tip and Tip Guard
on Gun
To avoid serious injury from skin injection
do not put your hand in front of the spray tip
when installing or removing the spray tip
and tip guard.
NO
To prevent spray tip leaks make certain spray
tip and tip guard are installed properly.
1. Relieve pressure. See Pressure Relief
Procedure, page 5. Engage trigger lock
(15).
2. Use spray tip (26) to align gasket and
seal (24) in the tip guard (25).
3. Insert tip (26) in guard (25).
3A6285D
YES
ti29141a
4. Verify spray tip and tip guard parts are
assembled in the order shown.
SPRAY
(26)
TIP
(24)
RUBBER
GASKET/METAL
SEAL
TIP
GUARD
(25)
RETAINING NUT
5. Install guard (25) over end of gun (1).
Hand tighten retaining nut.

Connect Gun to Sprayer

Make sure sprayer is turned off and
unplugged from power source. Refer to your
sprayer instruction manual for priming and
spray instructions.
1. Attach supply hose to sprayer fluid
outlet.
2. Attach other end of supply hose to gun
swivel (7). Use two wrenches (one on
the swivel (7) and one on the hose), to
tighten all connections securely.
3. Refer to sprayer instruction manual for
priming instructions.
Setup
ti29140a
7