Status Leds; Meaning Of The Leds On The Front Panel - Guntermann & Drunck DL-DVI-Vision-CAT series Installation And Operating Manual

Status LEDs

The LEDs on both the front and the back panel of the computer module and the
user module let you control the operational status of the KVM extender at any time.

Meaning of the LEDs on the front panel

Area LED
Ident. Ident.
Power Red.
Main
Status Trans.
System
Console Video
K/M
Network yellow
green
Status Meaning
on On as soon as the LED has been activated via web
application.
on The optional power pack is connected and supplies
voltage of 12 Volt.
off The optional power pack is not (properly) con-
nected.
on The power pack is switched on and supplies the
required voltage.
off The power pack is switched off or a connection to
the power network could not be established.
on The connection to the remote station has been
established.
off The connection to the remote station could not be
established.
on Device is ready for operation.
blinking Executing update.
fast Device is reset to default settings after pushing
the Reset button for a long time.
blinking
off Internal error
on A stable video signal has been detected at the
video input.
off The incoming video signal could not be detected
or its quality is not good enough to be processed.
on The keyboard has been detected.
blinking No keyboard connected or keyboard could not be
detected.
on The connection to the network has been success-
fully established.
off A connection could not be established.
flickering Network activity.
off No network activity
Status LEDs
G&D DL-DVI-Vision-CAT · 52