Installing the wine conditioning unit
Warning! Do not drop the appli-
ance. Risk of injury and damage.
Two people are required for installing
this wine conditioning unit.
Install the wine conditioning unit in a
stable, solid housing unit, positioned
on an even and level floor.
The niche must be horizontally and
vertically aligned.
The required ventilation cross-sec-
tions must be ensured (see "Installa-
tion - Ventilation" and "Building-in di-
mensions").
To install the wine conditioning unit,
you will need the following tools:
– Screwdrivers of various sizes
– A spirit level
– A tape measure
The following installation parts are
required:
– Ventilation grille
– Air filter
– Foam block for airflow separation
in the appliance plinth
– Screws to secure the appliance in
the niche
– Spanner to adjust height in the
niche
50
Setting up the wine condition-
ing unit
The air filter prevents soiling of the
compressor compartment to ensure
efficient functioning of the appliance.
Remove the protective foil from air fil-
ter .
Insert the air filter into the bottom left
of the appliance plinth.
Connect the wine conditioning unit to
the mains electrical supply (see
"Electrical Connection").
Position the wine conditioning unit in
front of the niche.
Unscrew feet clockwise until the
appliance is 4 mm less than the
height of the niche.