Installing The Wine Conditioning Unit; Before Installing The Wine Conditioning Unit; Setting Up The Wine Conditioning Unit - Miele KWT 6312 UGS Operating And Installation Instructions

Installation
Installing the wine conditioning
unit
Before installing the wine condition-
ing unit
 Take any accessories out of the appli-
ance.
 Remove the cable clip from the back
of the appliance (depending on
model).

Risk of damage and injury from
wine conditioning unit tipping over.
There is an increased risk of injury
and damage if the wine conditioning
unit is installed by a single person.
Two people are required for installing
the wine conditioning unit.
 Install the wine conditioning unit in a
stable, solid housing unit, positioned
on an even and level floor.
 The building-in niche must be hori-
zontally and vertically aligned.
 The required ventilation gaps must be
provided (see "Installation" – "Ventila-
tion" and "Building-in dimensions").
68
To install the wine conditioning unit,
you will need the following tools:
- Screwdrivers of various sizes
- A spirit level
- A tape measure
The following installation parts are
required:
- Ventilation grille
- Air filter
- Foam block for airflow separation
in the appliance plinth
- Screws to secure the appliance in
the niche
- Spanner to adjust height in the
niche

Setting up the wine conditioning unit

The air filter prevents soiling of the
compressor compartment to ensure
efficient functioning of the appliance.
 Remove the protective foil from air fil-
ter .
 Insert the air filter into the bottom left
of the appliance plinth.
 Connect the wine conditioning unit to
the mains electrical supply (see
"Electrical Connection").