To Change The Brightness Of The Temperature Display - Miele KWT 6321 UG Operating And Installation Instructions

Selecting further settings
To change the brightness of
the temperature display
The default brightness for the wine unit
temperature display is set to .
To change the brightness of the tem-
perature display (the temperature dis-
plays will change together):
 Touch and keep your finger on the
DynaCool On/Off sensor for approx. 5
seconds.
The sensor's indicator light flashes and
a  flashes in the temperature display
for the lower wine conditioning zone
(display on the right).
 Press one of the temperature setting
sensors as often as necessary until 
is displayed.
20
 Touch the DynaCool On/Off sensor
again.  will light up in the display.
 By pressing the sensors for setting
the temperature, you can now set the
display brightness. You can choose
between levels  to :
: Minimum brightness,
: Maximum brightness.
 To save the setting, touch the
DynaCool On/Off sensor.
 To exit settings mode, touch the On/
Off sensor for the whole wine unit.
Otherwise the appliance will automat-
ically switch to normal operation after
approximately two minutes.