Alarm; Over-Load Alarming; Low-Load Alarming; Low Battery Alarming - Adam Equipment BFW 75 Manual

3.7

ALARM

3.7.1 Over-load alarming

• When the sample weight on the scale is over the maximum capacity the
beep will sound and the display will show "EEE----".
• Remove the weight immediately to avoid any damage to the scale.

3.7.2 Low-load alarming

• If the platform is not placed on the scale the beep will sound.
• Place the platform on the scale before starting to weigh.

3.7.3 Low battery alarming

• When
• During re-charging, the symbol will keep flashing and it will disappear
once the charging is complete.
• If this symbol appears along with the beep, stop using the scale at once
and re-charge the battery immediately to avoid any damage to the
battery.

4.0 USER PARAMETERS

The following parameters can be set by the user by entering the function
setting mode. Press the [Tare] key while switching on the indicator. The first
parameter will be displayed along with the settings done previously.
• The available parameters can be cycled through by pressing the
[Mode] key.
• Not all parameters may be enabled. Some parameters may be set
during the initial configuration and the user is not given access to
them. In this case those will not be seen when the [Mode] key is
pressed. To use any of the parameters see the corresponding
section of the manual.
• Switch off and switch on again to return to weighing.
© Adam Equipment Company 2007
appears on the LCD, re-charge the battery.
8