Command Transfer Procedure; Command Transfer Sequence For Non-Compressed And The Run-Length Encoded Compression Modes; Table 3 Command Sequence For The Conventional Command Method Of Graphics Data Transmission - Epson L1300 Programming Manual

4.2 Command Transfer Procedure

4.2.1 Command transfer sequence for non-compressed and the run-length encoded compression modes

The following are the basic commands used in non-compressed and run-length encoded modes. The commands are
listed in order as they are sent:
Table 3 Command Sequence for the Conventional command method of graphics data transmission
Transfer cycle
By document
By page By raster
*Parameters and data format of non-compressed vs. run-length encoded transmissions are different in the Print
Raster Graphics command.
Revision: 2
Details of setting
1. Initialize settings
2. Printing method control
3. Set print format
(single sheet)
4. Set vertical position
5. Transfer data
6. Form feed
7. Terminate printing
Items set
Exit Packet Mode
Enter remote mode
Set Printer Timer
Job Start
Set Job Name
Paper Feed Setup
Set paper path
Set Media information
Set double paper print
Set user setting
Other Remote Commands
(optional)
Exit Remote Mode
1.2 Initialize printer
1.3 Select graphics mode
Set unit
2.1 Turn unidirectional mode on/off
2.2Select MicroWeave printing
mode
2.3 Select Monochrome or Color
2.4 Select Ink Drop Size
3.1 Set page format
3.2 Set paper dimension
3.3 Set Print method
4.1 Set vertical print position
5.1 Select color
5.2 Set horizontal print position
5.3 Print raster graphics: *
repeat above for each color
5.4 Print compulsory**
6.1 Form feed
7.1 Initialize printer
7.2 Enter Remote Mode
Load NVR Settings
Job End
Exit Remote Mode
Commands used
ESC SOH @EJL...
ESC (R
TI ***
JS ***
JH
SN
PP
MI
DP
US
ESC 00H 00H 00H
ESC @
ESC ( G
ESC ( U
ESC U
ESC ( i
ESC ( e
ESC ( c or ESC( C
ESC (S
ESC ( V or ESC
(v
ESC (r
ESC(/ or ESC ( $
ESC .
ESC ACK
FF
ESC @
ESC (R
LD
JE
ESC 00H 00H 00H
2016/08/25
Page: 17