Botex DMX DC-192 User Manual page 41

8.4.3 Editing chases
Adding a chase step
6. Hold down [Program] for about two seconds or until the PROG indicator stops flashing
on the display. As soon as the blackout indicator flashes, the programme mode is deacti‐
vated.
1. Hold down [Program] for about two seconds or until the PROG indicator flashes on the
display. When the indicator flashes, the recording mode is active and you can release the
button.
2. To select a chase press the corresponding [CHASE] button (1 to 12). The corresponding
LED lights up.
3.
Press [Tap/Disp], step indicator lights up on the display.
4. Press the scene bank UP / DOWN buttons to move manually through each section of the
chase step. Locate the chase step to which you want to add another step.
5.
Press [Tap/Disp] to exit the Step mode again. The step display in the display should then
be set off.
Operating
DMX DC-192
41
DMX controller