Botex DMX DC-192 User Manual page 30

Operating
Assigning the reverse joystick
(pan / tilt reversal)
DMX DC-192
30
DMX controller
6. Hold down [Program] for about two seconds or until the PROG indicator stops flashing
on the display. As soon as the blackout indicator flashes, the programme mode is deacti‐
vated.
1. Hold down [Program] for about two seconds or until the PROG indicator flashes on the
display. When the indicator flashes, the recording mode is active and you can release the
button.
2. Hold down [MODE] and press [FINE]. The LEDs for [ASSIGN] and [PAN] should now light
up.
3.
Hold down [MODE] again and press [FINE]. The LED for [REVERSE] should now light up.
4. Select the devices you want to assign pan / tilt reversal to. To do so, press the corre‐
sponding [FIXTURE] buttons (1 to 12). The LEDs of the selected devices light up. Ideally,
you should choose opposing devices for pan / tilt reverse For example, fixtures 1, 3, 5, 7
etc. should be assigned normally. Fixtures 2, 4, 6 etc. should be set up in the reverse
direction, so the units will react in the opposite direction when you turn the joystick
around. The movement of opposing devices should be in opposite direction.