Trigger - Hella Gutmann mega macs 50 User Manual

Trigger

NOTE
If the time axis is set at less than 1.0 s, the trigger can be selected. A trigger is required to display a voltage
curve. The trigger releases a new image as soon as the signal reaches a defined voltage.
After startup, mega macs 50 is always set to automatic triggering. In order to stabilise high-speed signals, it is
often necessary to change the trigger point. The required settings can be accessed under F2.
Zero line
AC/DC
Start/stop
Zero reset
1. Select and confirm > Trigger <.
Trigger edge
NOTE
> Positive edge < Trigger orientation towards rising voltages.
> Negative edge < Trigger orientation towards falling voltages.
Any change in the edge will displace the image towards the right or left.
Trigger settings
Edge: Positive
Mode: Auto
2. Select and confirm > Edge xx <.
Trigger edge
positive
negative
3. Select and confirm > positive < or > negative <.
Accept setting with
ESC
5 mega macs 50 Section M 5/10