Defining The Tp-580Ra Hdmi Line Receiver - Kramer DigiTOOLS TP-580RA User Manual

Defining the TP-580RA HDMI Line
Receiver
# Feature
PROG Micro USB Port
SETUP DIP-switches
IN LED
OUT LED
LINK LED
ON LED
HDBT IN RJ-45 Connector
HDMI™ OUT Connector
AUDIO OUT S/PDIF RCA
Connector
AUDIO OUT ANALOG 3.5mm
Mini Jack
IR 3.5mm Mini Jack Connector
RS-232 3-pin Terminal Block
Connector
12V DC Power Connector
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are
trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
TP-580RA – Defining the TP-580RA HDMI Line Receiver
Figure 1: TP-580RA HDMI Line Receiver
Function
Connect to a PC to perform firmware upgrades (via K-UPLOAD) and
work with the EDID Designer. K-UPLOAD and EDID Designer can
be downloaded from our Web site at: www.kramerav.com/support.
Used to set the device behavior (see
on page 11).
Lights green when an active far-end source HDMI input signal is
detected via the HDBaseT link (an HDMI signal is detected from a
source device connected to the HDBaseT transmitter that is
connected to this input).
Lights green when an acceptor device is detected on the HDMI
output.
Lights green when a link is established between the
the HDBaseT transmitter.
Lights green when the device receives power.
Connect to the RJ-45 OUT connector on an HDBaseT transmitter (for
example, TP-580T).
Connect to an HDMI acceptor.
Connect to a digital stereo audio acceptor.
Connect to an analog unbalanced stereo audio acceptor.
Connect to an external infrared emitter / sensor.
Connect to a controlled device (so that it can be controlled from a
remote serial controller); connect to a laptop to upgrade the firmware
or to a control system to serially control the TP-580RA.
12V DC connector for powering the unit.
Kramer Electronics Ltd.
Setting the DIP-Switches
TP-580RA and
5