Pentair FLECK 5800 LXT Installer Manual page 50

Installer Manual Fleck 5800 - LXT - Programming
6.4.2.2 Setting the salt amount
Set the salt amount in the system.
A Press MODE until display position point to the Salt Amount icon.
B Press and hold
C Set the salt amount with
D Press MODE to go to the next parameter, or press
validate the selection and return to the service mode.
6.4.2.3 Setting the water hardness
Set the water hardness in the system.
A Press MODE until display position point to the Hardness icon.
B Press and hold
C Set the water hardness with
D Press MODE to go to the next parameter, or press
validate the selection and return to the service mode.
6.4.2.4 Remaining capacity
Note
The remaining capacity indicate the amount of water the system still can treat until next
regeneration and cannot be adjusted.
A Press MODE until display position point to the Remaining Capacity icon.
B The display shows the remaining amount of water until next regeneration,
in liters (metric).
Note
This unit has a day of the week reserve. It calculates a reserve for each day of the week
based on the past four weeks.
50 / 88
or until the Programming icon appears.
or , 50 to 290 g/l (metric).
or until the Programming icon appears.
or , 30 to 2000 mgl (metric).
and hold to
and hold to
Ref. MKT-IM-005 / C - 22.05.2018