Brocade Communications Systems VDX 6940 Series Hardware Installation Manual page 94

CAUTION
Do not install the device in an environment where the operating ambient temperature might exceed 40°C (104°F).
CAUTION
Never leave tools inside the chassis.
Replacing an 1100W AC power supply
Use the following procedure to remove an 1100W AC power supply.
NOTE
Before beginning the replacement, refer to the precautions in "Power precautions."
1. If leaving the device in service while replacing a power supply, verify that the other power supply (the one not being replaced)
has been powered on for at least four seconds and has a steady green status LED.
2. Ensure that the replacement power supply has the same part number and airflow label as the power supply being replaced.
3. Unplug the power cord from the power supply that is being replaced.
4. Push the locking tab on the right lower corner of the power supply to the left and hold it there while using the handle on the
power supply to pull it straight out and away from the chassis. Pull the power supply out slowly to avoid catching a finger on the
locking tab.
94
Removal and Replacement Procedures
Brocade VDX 6940 Hardware Installation Guide
53-1003495-06