Brocade Communications Systems VDX 6940 Series Hardware Installation Manual page 44

FIGURE 19 Attaching the bracket extensions to the device
1. Extension brackets
Installing the device in the rack
Complete the following steps to install the device in the rack.
1. Position the device in the rack, as shown in
to the rack.
2. Attach the right front bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use
the upper and lower holes in the bracket.
3. Attach the left front bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
44
Figure 20, providing temporary support under the device until the rail kit is secured
2. Screws, 8-32 x 5/16-in., flathead Phillips
Brocade VDX 6940 Hardware Installation Guide
Mounting the device
53-1003495-06