Brocade Communications Systems VDX 6940 Series Hardware Installation Manual page 50

FIGURE 24 Attaching the front brackets
1. The Brocade device
2. Front brackets, right and left
Attaching the front brackets to the rack
Complete the following steps to install the device in the rack.
1. Position the device in the rack, as shown in
secured to the rack.
2. Attach the right front bracket to the right rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
3. Attach the left front bracket to the left rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts.
4. Use the upper and lower holes in the bracket. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb. (29 cm-kg).
50
(Figure 25), providing temporary support under the device until the rack kit is fully
3. Screws, 8-32 x 5/16-in., flathead Phillips
Brocade VDX 6940 Hardware Installation Guide
Mounting the device
53-1003495-06