Adding, Replacing, Or Removing A Transceiver - HP J3102A Installation Manual

C a u t i o n
12
Installation

Adding, Replacing, or Removing a Transceiver

When adding, removing, or replacing a transceiver from a module,
always remove the module from the Switch 2000 first. Otherwise, you
might interrupt proper switch operation and/or damage the module or
transceiver circuitry.
For proper cooling and for reduction of electromagnetic emissions,
ensure that a slot cover (provided with your Switch 2000) is installed on
any unused port or transceiver slot.
1. Disconnect any network cables attached to the module for which
you will add, replace, or remove a transceiver.
2. Remove the module from the Switch 2000.
a. Loosen the screws in the extractor handles of the module.
Figure 10. Removing the Module from the Slot
b. Simultaneously pull both extractor handles toward you until the
module releases from the slot and the Fault and status LEDs for
that slot are off.
c. Slide the module out of the slot.
Loosen These Two Screws