Flex Port Slot And Module Support; Back Of The Switches - HP Aruba 3810M Series Installation And Getting Started Manual

To accomplish this:
Restore the factory default
configuration
Note: These buttons are provided for your convenience. If you are concerned with switch security though, you should
make sure that the switch is installed in a secure location, such as a locked wiring closet. You can also disable these
buttons by using the front-panel-security command. See the 3810M Management and Configuration Guide for a
description of that command.

Flex Port Slot and Module Support

The 3810M family of switches features a module slot(s) that allows the user to customize the
uplink ports on the switch. Depending on the switch model, the slot supports either 40Gbps or
80Gbps of maximum bandwidth and therefore, not all modules are supported in all slots. See
Switch Module/Support
NOTE: The unsupported modules are mechanically prevented from installing into unsupported
slots.
Table 10 Switch Module/Support Matrix
Switch Model
JL071A Aruba 3810M 24G 1-slot
Switch
JL072A Aruba 3810M 48G 1-slot
Switch
JL073A Aruba 3810M 24G PoE+
1-slot Switch
JL074A Aruba 3810M 48G PoE+
1-slot Switch
JL075A Aruba 3810M 16SFP+ 2-slot
Switch
JL076A Aruba 3810M 40G 8SR PoE+
1-slot Switch

Back of the Switches

The back of all the 3810M switches is the same.
20 Introducing the 3810M switches
Do this:
1. Press Clear and Reset
simultaneously.
2. While continuing to press Clear,
release Reset.
3. When the Global Status LED
begins to fast flash orange (after
approximately 5 seconds), release
Clear.
Matrix, for the switch module/support matrix.
JL078A 1QSFP+
Yes
Yes
Yes
Yes
Yes
Yes
This will happen:
The switch removes all configuration
changes, restores the factory default
configuration, and runs self test.
Module Support
JL079A 2QSFP+
No
Yes
No
Yes
No
Yes
JL083A 4SFP+
Yes
Yes
Yes
Yes
Yes
Yes