Programming The Immobilizer System - Gilera Nexus 500 User Manual

VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
IF OWNERSHIP OF THE VEHICLE IS TRANSFERRED, THE RED-HANDGRIP KEY
(AS WELL AS THE OTHER KEYS) AND THE "CODE CARD" MUST ALSO BE
TRANSFERRED TO THE NEW OWNER.

Programming the immobilizer system

The procedure for programming the «PIAGGIO IMMOBILIZER» system and/or for
storing other key codes is described below.
Procedure start - red key
Make sure that the emergency cut-off switch is set to «ON» and the side stand is up.
Insert the red-handgrip key into the key switch (in «OFF» position) and turn it to
«ON». After 1-3 seconds, turn the key to «OFF» again and pull it out.
Intermediate step - black key
After pulling out the red key, insert the black key within 10 seconds and promptly turn
it to "ON". After 1-3 seconds, turn the key to "OFF" again and pull it out. In this way,
a maximum of 7 black keys can be programmed by repeating the above procedure
keeping the indicated times.
Proper programming check
Insert the red key disabling the transponder (i.e., tilt the key cap by 90°) and turn the
key to "ON". Perform the engine start-up operation. Ensure that the engine does not
start. Insert the black key and repeat the start-up operation. Check that engine starts.
24