Makita KP0810 Technical Information page 9

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -7. Electrical Parts in Handle Section
DISASSEMBLING
For replacing the electrical parts in Handle section;
1) Remove Rear cover by unscrewing two 4x18 Tapping screws.
(Fig. 30)
Note: It is impossible to remove Handle (R) from Handle (L)
without removing Rear cover.
2) Remove Handle (R) from Handle (L) by unscrewing five 4x18
Tapping screws as illustrated to left in Fig. 31.
Now the electrical parts illustrated to right in Fig. 31 can be
removed from Housing (L).
Fig. 31
Tapping screw 4x18 (5 pcs)
Note: If it is difficult to remove screws, put the machine
on two 1R350's as illustrated in Fig. 32.
Fig. 30
Tapping screw 4x18 (2 pcs)
Noise suppressor
Power supply cord
Controller
(KP0810C only)
Pickup coil (KP0810C only)
Fig. 32
Handle (R)
Rear cover
Switch
Handle (L)
1R350
P 9 /11