Download Print this page

Motor Section - Makita KP0810 Technical Information

82mm 3-1/4"
Hide thumbs

Advertisement

R
epair
[3] DISASSEMBLY/ASSEMBLY

[3] -2. Motor Section

DISASSEMBLING
1) Remove Poly V-belt 4-241 as illustrated in Fig. 2 to Fig. 4.
Note: Armature cannot be removed from Bracket complete until the Poly V-belt is removed from Pulleys.
2) Remove Rear cover by unscrewing two 4x18 Tapping screws. (Fig. 7)
Then disconnect Carbon brushes from Commutator of Armature.
3) Put the machine on two 1R350's with Bracket complete side up. (refer to Fig. 2.)
Unscrew four 4x18 Tapping screws that fasten bracket complete to Housing. (Fig. 8)
4) Remove Bracket complete together with Armature and Drum complete by levering off Bracket compete from Housing
using two 1R263's. Duct assembly can be removed together with Nozzle. (Fig. 9)
5) Remove V-Pulley 4-20L from Armature shaft by turning clockwise with Wrench 13. (Fig. 10)
Important: Wear gloves to prevent injury to be caused by the sharp edge of Drum complete.
6) Armature can now be removed from Bracket complete by tapping Bracket complete with plastic hammer
as illustrated in Fig. 11.
Fig. 7
Tapping screw 4x18
(2 pcs)
Rear cover
Fig. 9
Bracket complete
1R263
Housing
Fig. 10
Wrench 13
V-Pulley 4-20L
ASSEMBLING
Do the reverse of the disassembling steps.
Note: Do not forget to assemble Baffle plate, duct assembly and Nozzle to Housing. (Fig. 9)
1R263
Armature
Drum complete
Fig. 8
Armature
Baffle plate
Fig. 11
Armature
Bracket complete
P 4 /11
Tapping screw 4x18
(4 pcs)
Bracket complete
1R350
Bracket complete
Drum complete
Duct assembly
with Nozzle

Advertisement

loading

  Related Content for Makita KP0810

This manual is also suitable for:

Kp0810c