Makita KP0810 Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Drum and Drum Holder Section (cont.)
ASSEMBLING
1) Do the reverse of the disassembling steps 8) to 6). (Figs. 18 to 16)
Note: Do not forget to assemble Flat washer 10 to Drum holder complete as illustrated to left in Fig. 19
before assembling Ball bearing 6900LLB. Otherwise, Ball bearing 6900LLB cannot be assembled
correctly to Drum holder complete as illustrated to right in Fig. 19.
2) Assemble Drum holder section to the Rear cover side of Housing as illustrated in Fig. 20.
3) Do the reverse of the disassembling steps 4) to 1). (Figs. 14 to 12)
Fig. 19
Ball bearing 6900LLB
Flat washer 10
Fig. 20
Assembling Drum holder section to Housing
Tapping screw 5x25
Drum holder complete
Insert this loop portion of
Torsion spring 10 through
pin of Drum holder complete.
Put this end of Torsion spring 10
on the hook of Drum cover.
[Correct]
Drum holder complete
Housing,
viewed from Rear cover side
pin of Drum holder complete
Flat washer 10
Drum cover
hook of Drum cover
Tapping screw 5x25
Torsion spring 10
Flat washer 5
[Wrong]
Without Flat washer 10
Drum holder section,
fastened in place on Housing
P 6 /11