Makita KP0810 Technical Information page 3

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Poly V-Belt
DISASSEMBLING
1) Put the machine on two 1R350's with Belt cover side up. (Fig. 2)
2) Remove Belt cover by unscrewing Pan head screw M4x18. Poly V-belt 4-241 can now be seen. (Fig. 3)
Fig. 2
Base
Hold the machine securely
by putting Base and Front base
on the shaded portion of 1R350.
3) If you replace Poly V-belt 4-241 with new one,
remove it by cutting with nippers.
If you reuse Poly V-belt 4-241 to be removed,
remove it by following the steps below (Fig. 4):
1. Insert a slotted screwdriver between
Poly V-belt 4-241 and Bracket complete
as illustrated in Fig. 4.
2. While turning V-Pulley 4-37 (larger one)
in the direction of the black arrow, lift up
Poly V-belt 4-241 with the screwdriver.
ASSEMBLING
Assemble Poly V-belt 4-241 to V-Pulley 4-20L (smaller one of the two V-Pulleys) as illustrated in Fig. 5
then to V-Pulley 4-37 (larger one) as in Fig. 6. Then assemble Belt cover to Bracket complete. (Refer to Fig. 3)
Fig. 5
V-Pulley 4-20L Poly V-Belt 4-241
Engage all V-shaped ribs of Poly V-belt 4-241
with the grooves of V-Pulley 4-20L (small one).
Poly V-belt 4-241
V-Pulley 4- 20L
Belt cover
Front base
1R350
1R350
Fig. 4
Bracket complete
Fig. 6
Align the V-shaped ribs of Poly V-belt with the groove of
V-Pulley 4-37 (large one). While pressing down the two portions
of the Poly V-belt designated with the gray arrow, turn V-Pulley
4-37 in the direction of the black arrow until all ribs of the Poly
V-belt engage completely with all grooves of the both V-Pulleys.
Poly V-belt 4-241
V-Pulley 4-37
Fig. 3
Poly V-belt 4-241
V-Pulley 4-37
P 3 /11
Pan head screw M4x18
Belt cover
Poly V-belt 4-241
1R350
V-Pulley 4-37