Interconnecting The Blocks In "Valve_Lean - Siemens SIMATIC PCS 7 SMART Getting Started

Procedure
1. Open the "General" tab and "Inputs/Outputs" tab in the "Object Properties" dialog box for
each block.
– Enter the parameters for all blocks according to the table below.
– In the "General" tab, accept the default setting for "Create block icons" (no checkmark
2. Click "OK" for each block. Your settings are applied.
6.6.19

Interconnecting the blocks in "Valve_Lean"

Prerequisites
● The "Valve_Lean" CFC chart is open in the CFC Editor.
● The blocks have been created in the project library and parameters are assigned.
Procedure
1. Interconnect the blocks for each chart according to the table below.
2. Close the chart.
PCS 7 SMART Getting Started - Part 1 (V9.0 with APL)
Getting Started, 12/2017, A5E42181435-AA
Block Name in project
Pcs7DiIn FbkClose
Pcs7DiIn FbkClose
Pcs7DiIn FbkOpen
Pcs7DiIn FbkOpen
VlvL Valve
for the blocks Interloc, Permit and Protect).
Block description
Valve
Valve
I/O
SimOn.Value
SimPV_In.Value
(inverted after in‐
terconnection)
SimOn.Value
SimPV_In.Value
Feature.Bit4
I/O Block description
Ctrl FbkOpen
Ctrl FbkClose
Creating CFCs
6.6 Working with the CFC Editor
Meaning Value
Simulation ena‐ 1
bled
Simulation value 0
PV
Simulation ena‐ 1
bled
Simulation value 0
PV
Set switch or but‐ 1
ton mode (switch
mode)
I/O
SimPV_in
SimPV_In (inverted)
97