Example of setting S.BUS servo with T10J
3
1. Label on the servo.
CH1
CH6
CH2
CH4
CH3
Aileron
Aileron
Elevator
Rudder
Throttle
In case of GP
Put the name on the label and paste it on each servo.
2. Select [ SBUS LINK ] and access the setup screen shown below by press the jog key.
Sky Leaf Tip
3. Connect the aileron servo (CH1) to T10J and set the channel.
Receiver Battery
HUB
CH1
Aileron
T10J
4. Follow the same procedure to set the channels according to the label of each servo.
CH1
CH6
CH2
CH4
CH3
Aileron
Aileron
Elevator
Rudder
Throttle
In case of GP
9