FUTABA SkyLeaf Classic Instruction Manual page 18

This page is an explanation of when to make it into an engine.
Installation of Engine：GP kit only
8-1
1 1
● Cut the nose bottom film for engine cooling and
waste oil discharge.
＜ Fuselage nose bottom ＞
1 2
● Screw the Radial mount to the firewall with a screw.
● Except for the set with engine, the radial mount is not
included. Purchase the engine mount separately according
to the engine to be used.
1 3
● Fix the Radial mount securely with 4 × 20 screws
on the firewall, Spring washers and Nut with Claw.
● Drill a hole
i n t h e f u e l
pipe.
In a typical airplane the propeller axis is offset to the right.
However, this plane is offset to the left. Resolve the peculiar
habit of this airplane with a left offset.
18
● Cut the film.
4 × 20 screws and Spring washers
(It is unnecessary in case of EP.)
4
● Place the engine and cut the interfering side plate
parts such as silencer and needle.
● Apply oil resistant paint or adhesive to the balsa after
cutting and take countermeasures.
1 5
● Fix the Engine using a M3.5 x 16 hexagon screw (4
pieces) and a Spring washer attached to the radial
mount.
6 1
● Place the canopy on the fuselage and cut it if
there is a part interfering with the engine.
● If it interferes, cut the
canopy with dremel etc.
1 7
● Drill a hole for plug heat.
● The hole position varies depending on the engine
used. The figure is an example of an O.S. two cycle
engine.