FUTABA SkyLeaf Classic Instruction Manual page 20

This page is an explanation of when to make it into an engine.
8-2
Throttle setting：GP kit only
1
1
● Connect the Throttle Servo to the Receiver. For
S.BUS connection, connect to S.BUS port, otherwise
connect to 3CH port.
1
2
● Attach the Servo horn to the vertical position.
Choose the arm to be vertical and cut the others.
1 3
● Adjust with the throttle arm adjustment screw of
the engine so that the carburetor is in the middle
speed position and the throttle arm is vertical.
20
Neutral
Half throttle
(It is unnecessary in case of EP.)
1
4
● Both the engine and servo are fixed in the neutral
position by clamping the set screw of the throttle
adjuster.
1 5
● Adjust with the transmitter END POINT(ATV, EPA)
function so that the throttle stick is high (upper side)
and the carburetor is fully opened.
Carburetor
full open
1 6
● Adjust with the transmitter END POINT(ATV, EPA)
function so that the throttle stick is low (bottom
side) and the carburetor is fully closed.
Carburetor
full close
Hight
Low