FUTABA SkyLeaf Classic Instruction Manual page 19

This page is an explanation of when to make it into an engine.
1 8
● Install the Fuel tank to the fuselage with Hook-
and-Loop Tape.
1 9
● Assemble the mount for Throttle Servo with
CA glue.
11
● Link servo and engine throttle. Make it work smoothly.
● Drill a hole in the wood
s c r e w i n t h e s e r v o
mount. Fix the servo
with 4 wood screws.
● Cut the excess
r o d a f t e r
adjusting the
length.
If the Rod is in contact with the metal part of the
engine, noise may occur due to vibration and there is
a danger of malfunction.
1 10
● Depending on the position of the throttle of the
engine to be used, install Throttle Servo.
CH3
Throttle
● Depending on the engine you have
chosen, there are also cases here.
● Adhere the Servo mount to the side
plate with CA glue.
● The height of the servo mount is adjusted
so that the rod operates smoothly.
● Drill a hole where Throttle Rod
operates smoothly. In the case
of the O.S. 46 engine, one of the
rectangular long holes opened
from the beginning can be used.
● Connect the crank
s i d e o f T h r o t t l e
Rod to the throttle
of the engine.
(It is unnecessary in case of EP.)
● For S.BUS connection
Throttle CH3 servo to
throttle.
● A t t a c h i n g t h e
crank of Throttle
R o d i s d o n e b y
r e m o v i n g t h e
throttle arm from
the engine.
19