Yamaha R25 Series Owner's Manual page 29

Pass switch "PASS"
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
TIP
When the switch is set to low beam,
both headlights for low beam come on.
When the switch is set to high beam,
both headlights for high beam come
on.
Turn signal switch " / "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12362
Horn switch "
Press this switch to sound the horn.
Start/Engine stop switch "
To crank the engine with the starter,
set this switch to "
the switch toward "
for starting instructions prior to starting
EAU85410
the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard lights switch " /OFF"
The hazard lights (simultaneous flash-
ing of all turn signal lights) are used in
case of an emergency, such as to warn
EAU12461
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
Set this switch to " " to turn on the
". When
hazard lights. To turn off the hazard
lights, set the switch to "OFF".
Instrument and control functions
EAU12501
"
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU68270
/ / " gine not running, otherwise the bat-
tery may discharge.
", and then slide
". See page 6-2
" to stop the en-
EAUN2210
4-11
ECA10062
4