Yamaha R25 Series Owner's Manual page 27

Brightness: this function allows
you to adjust the brightness of the
indicator light.
To adjust the shift timing indicator light
1. Turn the key to " ".
2. Push and hold the "SELECT" but-
ton.
3. Turn the key to " ", and then re-
lease the "SELECT" button after
five seconds. The shift timing indi-
cator light can now be adjusted.
To set the flashing pattern
1. Push the "RESET" button to select
one of the following flashing pat-
tern settings:
On: the indicator light stays
on when activated. (This set-
ting is selected when the indi-
cator light stays on.)
Flash: the indicator
flashes when activated. (This
setting is selected when the
indicator light flashes four
times per second.)
Off: the indicator light is deac-
tivated; in other words, it
does not come on or flash.
(This setting is selected when
the indicator light flashes
once every two seconds.)
2. Push the "SELECT" button to con-
firm the selected flashing pattern.
The shift timing indicator light
changes to the activation point
setting mode.
The tachometer will show the current
setting r/min for the activation point
and deactivation point setting modes.
To set the shift activation point
TIP
The shift timing indicator light activa-
tion point can be set between 7000
r/min and 15000 r/min. From 7000
r/min to 12000 r/min, the indicator light
can be set in increments of 500 r/min.
From 12000 r/min to 15000 r/min, the
light
indicator light can be set in increments
of 200 r/min.
1. Push the "RESET" button to select
the desired engine speed for acti-
vating the indicator light.
4-9
Instrument and control functions
2. Push the "SELECT" button to con-
firm the selected engine speed.
The control mode changes to the
deactivation point setting mode.
To set the deactivation point
TIP
The shift timing indicator light de-
activation point can be set be-
tween 7000 r/min and 15000
r/min. From 7000 r/min to 12000
r/min, the indicator light can be set
in increments of 500 r/min. From
12000 r/min to 15000 r/min, the in-
dicator light can be set in incre-
ments of 200 r/min.
Be sure to set the deactivation
point to a higher engine speed
than for the activation point, other-
wise the shift timing indicator light
will not come on.
1. Push the "RESET" button to select
the desired engine speed for de-
activating the indicator light.
2. Push the "SELECT" button to con-
firm the selected engine speed.
The control mode changes to the
brightness setting mode.
4