Ford Edge 2016 Owner's Manual page 270

Drive cautiously when using a full-size
dissimilar spare wheel and tire assembly
and seek service as soon as possible.
Tire Change Procedure
WARNINGS
When one of the front wheels is off
the ground, the transmission alone
will not prevent your vehicle from
moving or slipping off the jack, even if your
vehicle is in park (P).
To help prevent your vehicle from
moving when you change a tire, be
sure the parking brake is set, then
block (in both directions) the wheel that
is diagonally opposite (other side and end
of your vehicle) to the tire being changed.
If your vehicle slips off the jack, you
or someone else could be seriously
injured.
Do not attempt to change a tire on
the side of the vehicle close to
moving traffic. Pull far enough off the
road to avoid the danger of being hit when
operating the jack or changing the wheel.
To lessen the risk of personal injury,
do not put any part of your body
under your vehicle while changing a
tire. Do not start the engine when your
vehicle is on the jack. The jack is only
meant for changing the tire.
Note: Passengers should not remain in your
vehicle when the vehicle is being jacked.
1. Park on a level surface, set the parking
brake and activate the hazard flashers.
2. Place the transmission in park (P) and
turn the engine off.
Edge (CDQ, CWB) Vehicles Built From: 07-12-2015, GT4J 19A321 AKA enGBR, First Printing
Wheels and Tires
E175447
3. Block both the front and rear of the
4. Lift the carpeted load floor panel and
5. Remove the steel winged washer nut
6. Remove the spare tire from the spare
7.
8. Loosen each wheel lug nut one-half
E145908
9. The vehicle jacking points are shown
266
wheel diagonally opposite the flat tire.
For example, if the left front tire is flat,
block the right rear wheel.
secure in the up position with the
hanger clip.
securing the spare tire by turning it
counterclockwise.
tire compartment.
Remove plastic wing nut and jack and
lug wrench assembly. Detach lug
wrench from jack by turning the jack
hex nut drive screw counterclockwise.
turn counterclockwise, but do not
remove them until the wheel is raised
off the ground.
above, and are depicted on the yellow
warning label on the jack.