Advertisement
3. Cut the ties securing the tank brackets and move them
out of the way.
4. Align the center hole over the mounting pin that points
straight up on the as shown in
G013619
Figure 8
1. Tank collar
2. Mounting pin
Important: If you do not install the LPG tank
correctly, the valves and gauges may not function
properly.
5. Latch the brackets and ensure that the tank is securely
fastened to the machine.
6. Carefully connect the fuel hose. Make sure the hose is
not kinked.
7. Slowly open the fuel valve to equalize the pressure in
the tank. If you open the fuel valve too quickly, the
pressure relief valve is equipped with a back pressure
check valve that will shut off the fuel supply. If this
happens, close the fuel valve completely and wait five
seconds. Slowly open the fuel valve.
3
2
1
Figure 9
1. LPG fuel hose connection
fitting
2. Tank valve
Figure
8.
3. Center hole
g030557
3. Fuel gauge
8. Check for leaks as described in the Safety section of
the Operator's Manual.
3
Checking the Engine-Oil Level
No Parts Required
Procedure
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Servicing the
Engine-Oil Level in the Operator's Manual.
4
Checking the Tire Pressure
No Parts Required
Procedure
Pressure: 13 psi (90 kPa)
Note: Check the tire pressure before starting the machine.
Refer to your Operator's Manual for the correct tire type,
correct air pressure needed, and procedure.
5
Checking the Wheel Lug Nut
Torque
No Parts Required
Procedure
Before you start the engine and use the machine, check the
wheel lug nut torque; refer to Checking the Wheel Lug Nuts
in the Operator's Manual
4
Advertisement
