Advertisement
4. Plug the harness connector into the seat switch located
under the seat towards the front.
1. Seat switch
2. Flange nuts
11
Checking the Seat Belt
(International Machines Using
Gasoline Only)
No Parts Required
Procedure
Important: Ensure the bolt torque is set between 49
to 61 ft-lb (67 to 83 N-m).
Check the seat belt angle and the seat belt bolt torque before
operating.
1. Check the angle of the seat belt compared to the
bottom of the seat. The angle needs to be 47 degrees.
See
(Figure
18)
2. If needed, set the seat belt to the correct angle.
3. Check and set the bolt torque between 49 to 61 ft-lb
(67 to 83 N-m).
Figure 17
3. Harness connector
1. Side of seat
2. Seat belt bolt, Set torque
between 49 to 61 ft-lb (67
to 83 N-m)
12
Installing the Motion-Control
Levers (International Machines
Using Gasoline Only)
Parts needed for this procedure:
1
Right-control lever
1
Left-control lever
4
Bolt (3/8 x 1 inch)—2 are assembled
4
Nut (3/8 inch)—2 are assembled
Procedure
1. Rotate the motion-control levers to the upright
position.
2. Loosely install the control levers on the inside of the
posts, using 4 bolts and 4 nuts.
Note: Install the control levers in the top and middle
holes for the high position or the middle and bottom
holes for the low position, as desired.
8
1
3
g014862
Figure 18
3. 47 degrees
2
Advertisement
