Toro Z Master series Setup Instructions page 7

Figure 13
3. Secure the seat plate to the seat with 4 spacers and 4
flange nuts (3/8 inch).
Figure 14
4. Plug the harness connector into the seat switch located
under the seat towards the front.
5. Install the seat to the machine frame with 4 flange nuts
(3/8 inch).
1. Harness connector
Installing the Seat on Models with a
Tilting Seat
1. Tilt the seat frame up.
2. For deluxe seats only, install the spacers as shown in
Figure 16.
For machines with a deluxe seat only
1. Deluxe seat
2. Long spacer
3. Install the seat to the seat frame with 4 flange nuts (3/8
inch)—Figure 17.
7
Figure 15
2. Flange nuts
g030558
Figure 16
3. Seat frame
4. Short spacers