Toro Z Master series Setup Instructions page 9

Figure 19
1. Bolt (3/8 x 1 inch)
2. Handle
3. Raise the levers and align them together in the neutral
position and tighten the bolts.
Figure 20
Note: If the machine is not properly tracking, refer to
Adjusting the Tracking in your Operator's Manual.
3. Control lever
4. Nut (3/8 inch)
13
Installing the Lift-Assist Pedal
(International Machines Using
Gasoline Only)
Parts needed for this procedure:
1 Carriage bolt (3/8 x 1-1/2 inches)
1 Flange locknut (3/8 inch)
Procedure
1. If needed, loosen the existing bolt and nut for the
lift-assist pedal.
2. Rotate the lift-assist pedal to the correct position
and install the carriage bolt (3/8 x 1-1/2 inches) and
locknut (3/8 inch)
3
1. Lift-assist pedal
2. Flange locknut (3/8 inch)
9
(Figure 21). Tighten both bolts.
1 2
Figure 21
3. Carriage bolt (3/8 x 1-1/2
inches)
g016346