Advertisement
Figure 26
2. Install the lanyard clips onto the long bolts (1/2 x
3-1/4 inch).
Note: Make sure the bent tab points toward the head
of the bolt.
Figure 27
3. Lightly oil the ends of the center roll bar section.
4. Loosely install the center roll bar section using 2 bolts
(1/2 x 3-1/4 inch) and 2 flange nuts (1/2 inch).
Note: Install the bolts from the outside of the roll bar.
Note: Install the lanyard tab oriented as shown in
Figure 28
and pointing forward.
5. Raise the roll bar into the upright position and secure
it with the pins and hairpin cotter pins fastened to the
lanyards.
g030555
6. Torque all of the lower fasteners, attached to the
machine frame, to 30 ft-lb (40.7 N-m).
7. Tighten the center roll-bar bolts (1/2 x 3-1/4 inch) so
it rotates freely with some resistance.
Note: No more than one thread should be exposed
outside the nut.
12
Figure 28
Figure 29
Advertisement
