Toro Z Master series Setup Instructions page 11

15
Installing the ROPS Hardware
(LPG Machines Only)
Parts needed for this procedure:
1 Bolt (1/2 x 3-1/4 inch)
1
Locknut (1/2 inch)
Procedure
Install the bolt (1/2 x 3-1/4 inch) and locknut (1/2 inch)
into the open hole in the Roll-Over Protection System
(ROPS)—Figure 25. This will prevent the roll bar from
hitting the cylinder when lowered to the down position.
2
1
Figure 25
1. Locknut (1/2 inch)
2. ROPS
3
G013506
3. Bolt (1/2 x 3-1/4 inch)
16
Installing the ROPS
(International Machines
Using Gasoline Only)
Parts needed for this procedure:
1 Roll-Over Protection System (ROPS) Kit
Procedure
Install the Roll-Over Protection System (ROPS) Kit. Follow
the instructions included with the ROPS Kit.
17
Installing the ROPS (Diesel
Machines Only)
Parts needed for this procedure:
1 Roll bar, right section
1 Roll bar, left section
1 Roll bar, center section
8 Bolt (3/8 x 1 inch)
8 Curved washer
8 Flange nut (3/8 inch)
2 Bolt (1/2 x 3–1/4 inch)
2 Flange nut (1/2 inch)
Procedure
1. Loosely install the right and left roll bar section to the
frame, with 8 bolts (3/8 x 1 inch), 8 curved washers,
and 8 flange nuts (3/8 inch).
Note: Install the curved washer cone toward the bolt
head.
11