Table of Contents
Advertisement
13 Fast Access Menu
The Fast Access menu contains the list of probes and values that are automatically emptied by the board such
as the superheat and percentage of valve opening. The values: nP or noP stands for probe not present or value
not emptied, and Err means the value is out of range, or the probe is damaged, not connected or configured
incorrectly.
ENTERING THE FAST
ACCESS MENU
To select an entry, press the
or
, then press
view the value or to move to the
next value.
EXIT
Table 13-1 - Fast Access Menu
How to Move a Parameter From Pr1 to Pr2 Level and Vice Versa
HM Access to clock menu or reset the RTC alarm
An Value of analog output
SH Value of superheat. nA= not Available
oPP Percentage of valve opening
dP1 (Pb1) Value read by probe 1
dP2 (Pb2) Value read by probe 2
dP3 (Pb3) Value read by probe 3
dp4 (Pb4) Value read by probe 4
dP5 (Pb5) Temperature read by probe 5 or value obtained from pressure
transducer
to
dP6 (Pb6) Value read by probe 6
dPP Pressure value read by (Pb5) transducer
rPP Virtual pressure probe, only on slave
L°t Minimum room temperature
H°t Maximum room temperature
dPr Virtual probe for room temperature regulation [rPA and rPb]
dPd Virtual probe for defrost management [dPA and dPb]
dPF Virtual probe for fan management [FPA and FPb]
rSE Real thermoregulation setpoint: the value includes the sum of SET,
HES and/or the dynamic setpoint if the functions are
Press and release the up arrow key. The duration of
the menu in case of inactivity is about 3 minutes.
Depending on the configuration of the board, the
values display.
Press together or wait the time out for 60 seconds.
Fast Access Menu • 23
Advertisement
Table of Contents
