Siemens SITRANS F Series Quick Start Manual page 5

8. Reinstate display cover until mechanical stop. Wind back lid by one turn.
9. Mount o-ring by pulling it over the display cover and turn display cover until you feel friction from the o-ring on both sides.
Wind display cover further by one quarter of a turn to seal on the o-ring.
10. Reinstate and tighten lid lock screw.
Connecting
WARNING
Access to terminal space
As long as the device is energized, the lid of the housing on the sensor connection area may only be opened by qualified
personnel.
Before removing the terminal cover, the auxiliary power must be switched off from all poles.
Following installation, the terminal cover must be screwed back on again.
1. Remove blind plugs where required and mount cable glands.
①
Input/output connection (channels 2 to 4)
②
Power supply connection
③
Current output/HART connection (channel 1)
2. Remove lid lock screw for terminal connections lid.
3. Remove lid for terminal connections.
SITRANS FCT030 transmitter
A5E03922778-006, 12/2013
5