Miele CS 1013-1 Operating And Installation Instructions page 10

Warning and Safety instructions

Miele can only guarantee the safety of the appliance when
genuine original Miele replacement parts are used. Faulty
components must only be replaced by Miele spare parts.

The hob is not intended for use with an external timer switch or a
remote control system.

Connection to the gas supply must be carried out by a registered
gas installer. The hob may be connected to the electrical supply by a
fused plug and switched socket. If you wish to connect it to a fused
spur connection, or if the plug has been removed or the connection
cable is not supplied with a plug, the hob must be connected to the
mains supply by a registered electrical worker.

During installation, maintenance and repair work, the hob must be
disconnected from the mains electricity supply. The gas supply must
also be shut off. Depending on territory this is done in one of several
different ways:
– the mains fuse has been removed, or
– the screw-out fuse is removed (if applicable), or
– switch off at the wall socket and withdraw the plug from the
socket. Pull by the plug and not by the mains connection cable to
disconnect from the mains electricity supply.
– the gas inlet valve is closed.

Danger of electric shock!
Do not use the hob if it is faulty. Shut off the gas supply and contact
Miele.

If the appliance is installed behind a furniture door, do not close
the door while the appliance is in operation. Heat and moisture
would build up behind a closed furniture door, potentially causing
damage to the appliance, the furniture unit and the flooring. Wait
until the appliance has cooled down completely before closing the
furniture door.
10