Transport, Packaging And Storage - WIKA LF-1 Operating Instructions Manual

4. Transport, packaging and storage

4. Transport, packaging and storage
4.1 Transport
Check the submersible pressure sensor for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
Make sure that the connection contacts are not damaged.
4.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in installation site, sending for
repair).
Prior to storage, clean the submersible pressure sensor thoroughly (→ see chapter 7.3.2 "Cleaning")
Permissible conditions at the place of storage:
Storage temperature: -40 ... +80 °C
■
Humidity: 45 ... 75 % relative humidity (no condensation)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Humid or wet environment
■
Hazardous environments, flammable atmospheres
■
WIKA operating instructions submersible pressure sensor, model LF-1
EN
9