Jeep Wrangler 1999 Electronic Service Manual page 1454

TJ
REMOVAL AND INSTALLATION
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB . . . . . . . . . . . . . . . . . . . . . . . . . 7
CITYLIGHT LAMP BULB . . . . . . . . . . . . . . . . . . . . 6
REMOVAL AND INSTALLATION
HEADLAMP BULB
REMOVAL
(1) Release the hood latches and open hood.
(2) Disconnect the headlamp wire harness connec-
tors.
(3) Remove the headlamp bezel retaining screws
and bezel (Fig. 1).
(4) Remove the headlamp retaining ring screws
and retaining ring (Fig. 2).
(5) Remove the headlamp from vehicle.
(6) Remove rubber seal boot (Fig. 3).
(7) Disengage wire retaining ring from headlamp
(Fig. 4).
(8) Pull the headlamp bulb from back of headlamp
assembly (Fig. 5).
Fig. 1 Headlamp Bezel
LAMP BULB SERVICE
INDEX
page
HEADLAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . 5
LICENSE PLATE LAMP BULB . . . . . . . . . . . . . . . 7
REAR FOG LAMP BULB . . . . . . . . . . . . . . . . . . . 7
TAIL LAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . . 6
Fig. 2 Headlamp Retaining Ring
Fig. 3 Headlamp Rubber Seal Boot
LAMPS 8L - 5
page