Inspecting And Cleaning The Transducer Face - Simrad ES120-7C Installation Manual

Simrad ES120-7C Installation Manual
http://www.jotun.com/ww/en/b2b/technical-info/tds/index.aspx
International Marine Coatings
• : International Marine Coatings
Manufacturer
• Stoneygate Lane, Felling, Gateshead, Tyne & Wear, NE10 0JY United Kingdom
Address:
•
Manufacturer's website
Products:
• Intersleek 1100SR
– : Intersleek 737
Primer
Apply 50 µm dry film thickness.
– : Intersleek 1100SR
Paint
Apply 150 µm dry film thickness.
• Intersmooth 7465Si SPC
– : Intergard 269
Primer
Apply 40 µm dry film thickness.
– : Intersmooth 7465Si SPC
Paint
Apply 100 µm dry film thickness.
The list can also be found on http://www.simrad.com.
Related topics
Transducer handling and maintenance, page 13
Painting the transducer face, page 18

Inspecting and cleaning the transducer face

Marine growth (biological fouling) on the transducer face reduces the ES120-7C
performance. For this reason, it is important to keep the transducer face clean. Every time
your vessel is in dry dock, you must remove the marine growth. At the same time, you must
inspect the transducer closely for physical damage.
Prerequisites
The following tools and consumables are required.
• Personal protection
• Fresh water
16
: www.international-marine.com
330254/B